|
This THREAD brought to you by... |
|
 |
Founding Member
|
|
Posts: 496
Join Date: September 2002
Location: ATL
|
|
|
Show me your gauge setups! -
08-27-05, 04:45 PM
I am thinking either Autometer Ultralite or some Red Digitals, three to grace the a-pillar, and possibly two more around the gauge cluster, unless I can find that place that makes radio delete panels for gauges. 
Still doing Mustang vinyl parts!
2004 Mustang GT Roush V1 S-Trim - Sold; 2001 Mustang GT Bullitt Novi 2000 T56 - Sold; 2002 Mustang GT Vert on BBSs - Sold; 2002 Mustang GT T-Trim T56 Coupe - Sold; 2000 Mustang GT w/ NX - Sold; 1988 Mustang LX Coupe - Sold (Plus nine Non-Mustangs)
|
 |
Banned
|
|
Posts: 4,868
Join Date: June 2000
Location: Allentown State Hospital, Pa
|
|
|
08-27-05, 07:43 PM
Actually I would like to see everyones gauge setups too.
|
 |
Official Member
|
|
Posts: 891
Join Date: April 2004
Location: Lawrenceville, GA
|
|
|
08-27-05, 08:09 PM
Virgin Ford gauges. (Yea, ignore the "35th anniv." thing) 
Last edited by 40th GT; 08-27-05 at 08:12 PM.
|
 |
I like Pro3 and all I got was this crappy CT.
|
|
Posts: 3,298
Join Date: July 2003
Location: StateCollege PA
|
|
|
08-27-05, 09:25 PM
tomustang.... u really really need to do something about the steering wheel of yours...  FR500???
here is mine. same as everyone tho..
01 Trueblue GT 5spd
Bullit Gas Cap, 275/35/18&28535/18 NT555, Roush full kit with thier expensive side exhaust, FRPP STB, S281 wing, Sportline, C&L elbow, BBK coated LT, BBK custom H, KingCobra clutch, Pro3i C/C Plate, Bilstein shock/strut, pro5.0 w/custom lever, AFS 18x9&18x10.5, FR500 steering wheel, Alum Driveshaft, Cobra Mirror, Saleen gill
Other toy 2007 Mazda RX-8 Grand Touring Mity's photos
|
 |
Official Member
|
|
Posts: 487
Join Date: February 2004
Location: Ft Lauderdale
|
|
|
08-27-05, 09:40 PM
|
|
Banned
|
|
Posts: 4,868
Join Date: June 2000
Location: Allentown State Hospital, Pa
|
|
|
08-27-05, 09:49 PM
Mity the wheel was fine but the previous owner put one of those stick-on carbon fiber trims on it and it peeled the leather off 
|
 |
Official Member
|
|
Posts: 209
Join Date: March 2005
Location: Columbia, South Carolina
|
|
|
08-27-05, 10:10 PM
WHITE STANG....where did you get your shiftlight and steering column pod, i've been looking everywhere for that!!!
t70 diy single kit, stock 4.6 with all the boltons, 42lb injectors, 255 walbro, built aode, 4.10's, mt et radials, sct xcalII dyno tuned.
|
 |
Founding Member
|
|
Posts: 3,096
Join Date: April 2001
Location: Tucson, AZ
|
|
|
08-27-05, 10:37 PM
Quote:
|
Originally Posted by stonegod85
WHITE STANG....where did you get your shiftlight and steering column pod, i've been looking everywhere for that!!!
|
Autometer, summit, jegs, you name it, they sell them.
Don't have a Mustang anymore. I'm a loser now.
|
 |
Official Member
|
|
Posts: 167
Join Date: October 2003
Location: NY
|
|
|
08-27-05, 10:39 PM
2000 Automatic GT
JLT Intake - Accufab 70mm TB - P&P'd Plenum - Bassani Catted X - MAC Catback
Pulleys - 180t - 3.73's - Tranny Cooler w/ Gauge - Predator
Tokico kit - Steeda front swaybar - Subframes - Cobra Front Brakes w/stainless lines
Cobra Anniv. rims in silver 17x9 wrapped in 255/45/17 Firestone Firehawk Wide Ovals
Rotten Puppets "Where the Puppets run the show"
|
 |
Official Member
|
|
Posts: 149
Join Date: September 2003
Location: Eddyville, KY
|
|
|
08-27-05, 10:52 PM
2003 Dark Shadow Grey Ford SVT Lightning
|
 |
Founding Member
|
|
Posts: 1,681
Join Date: August 2002
Location: Clovis, CA
|
|
|
08-28-05, 08:06 AM
I believe the shiftlight White Stangs using is the Stewart Warner shift light/digital tach, it fits in any 2" opening.
  
I think this is the Pod he's got it's also a S-W piece (PN 116003), not Autometer
Here's a link to the S-W website for more info.
Stewart Warner Performance Gauges
Last edited by jeffnoel; 08-28-05 at 08:13 AM.
|
|
Founding Member
|
|
Posts: 496
Join Date: September 2002
Location: ATL
|
|
|
08-28-05, 08:09 AM
Autometer phantoms seem popular.
Still doing Mustang vinyl parts!
2004 Mustang GT Roush V1 S-Trim - Sold; 2001 Mustang GT Bullitt Novi 2000 T56 - Sold; 2002 Mustang GT Vert on BBSs - Sold; 2002 Mustang GT T-Trim T56 Coupe - Sold; 2000 Mustang GT w/ NX - Sold; 1988 Mustang LX Coupe - Sold (Plus nine Non-Mustangs)
|
|
I like Pro3 and all I got was this crappy CT.
|
|
Posts: 3,298
Join Date: July 2003
Location: StateCollege PA
|
|
|
08-28-05, 08:41 AM
would shift light(with tach) work on our car without getting Tach signal adaptor on our car? i know we need some adapter for aftermarket tach to work..
01 Trueblue GT 5spd
Bullit Gas Cap, 275/35/18&28535/18 NT555, Roush full kit with thier expensive side exhaust, FRPP STB, S281 wing, Sportline, C&L elbow, BBK coated LT, BBK custom H, KingCobra clutch, Pro3i C/C Plate, Bilstein shock/strut, pro5.0 w/custom lever, AFS 18x9&18x10.5, FR500 steering wheel, Alum Driveshaft, Cobra Mirror, Saleen gill
Other toy 2007 Mazda RX-8 Grand Touring Mity's photos
|
|
Founding Member
|
|
Posts: 1,681
Join Date: August 2002
Location: Clovis, CA
|
|
|
08-28-05, 10:12 AM
Nope you need a tach adapter for all except the Raptor Shift Light.
|
|
Founding Member
|
|
Posts: 1,681
Join Date: August 2002
Location: Clovis, CA
|
|
|
08-28-05, 10:15 AM
Here's a pic of mine, so far just water temp and oil pressure. Autometer Carbon Fiber Series, however if you notice the small switch to the left of the wheel that allows me to select between water temp and oil temp. I have both sending units wired to the switch and the switch to the gauge.
|
 |
Official Member
|
|
Posts: 638
Join Date: June 2004
Location: Oxnard, CA
|
|
|
08-28-05, 12:16 PM
2004 Ford Mustang GT Sonic Blue
K&N Air Filter, Bassani Cat-Back, Bassani X-Pipe with Cats, MGW Shifter, 17x10.5 Non-Deep Dish Bullitt Wheels(Rear), Steeda Sport Springs, Sequential Turn Signals, Bullitt Fuel Door, MGW Race Knob, 10th Anniversary Cobra Shifter Boot, Billet Shifter Trim, Simco Gauge Cluster, Triple Chrome MGW Stuff.
Quit Modding: Saving up for a '06/'07 Saleen.
http://www.stangfreak.com Southern California/Ventura County Mustangs. Forums and more.
|
 |
I tripped & fell down and cut myself & got blood
on my Abercrombie & Fitch shirt & tore my Abercrombie & Fitch shirt & now
I can't wear my Abercrombie & Fitch shirt because I got blood on it.
And it got torn, too.
|
|
Posts: 475
Join Date: October 2004
Location: La Mirada, CA
|
|
|
08-28-05, 12:26 PM
Here is my set up. autometer Phantom Air/Fuel, Oil Press. Volts, and Nitrous. The blue screen is a APEXi Rev/Speed Meter, probley the coolest tac. and shift light.
|
|
I like Pro3 and all I got was this crappy CT.
|
|
Posts: 3,298
Join Date: July 2003
Location: StateCollege PA
|
|
|
08-28-05, 12:32 PM
Quote:
|
Originally Posted by jeffnoel
Nope you need a tach adapter for all except the Raptor Shift Light.
|
so i do need to get some tach signal adapter then. where can i get them?
01 Trueblue GT 5spd
Bullit Gas Cap, 275/35/18&28535/18 NT555, Roush full kit with thier expensive side exhaust, FRPP STB, S281 wing, Sportline, C&L elbow, BBK coated LT, BBK custom H, KingCobra clutch, Pro3i C/C Plate, Bilstein shock/strut, pro5.0 w/custom lever, AFS 18x9&18x10.5, FR500 steering wheel, Alum Driveshaft, Cobra Mirror, Saleen gill
Other toy 2007 Mazda RX-8 Grand Touring Mity's photos
|
 |
Official Member
|
|
Posts: 926
Join Date: May 2004
|
|
|
08-28-05, 01:33 PM
"When you make peace with authority, you become authority," - Jim Morrison.
1998 GT Vert Auto, Atlantic Blue
PI swap, MAC Polished Plenum, BBK CAI w/70mm TB, UD pullies, Mustangtuning O/R X-Pipe, Flows, 4 point rollbar, rear seat delete, 5% rear/35% front tint, Infinity speakers, A4004T, Optima Yellow Top, FR springs,
Waiting to be installed: Steeda CC plates, BM trans cooler, transgo shift kit, 6 point rollbar.
FOR SALE: 10 lb polished bottle, local pickup only, SE michigan
|
 |
Moderator
|
|
Posts: 6,224
Join Date: September 2001
Location: HOCKEYTOWN ® , MI
|
|
|
08-28-05, 10:14 PM
Representing the 1% of Mustang owners who are wingless
'01 Cobra Coupe #918 of 3867
-Delivered 6.09.01
-Steeda Tri Ax
-Full Length Densecharger CAI
-Catted Magnaflow X & Magnaflow catback
-Full Length Maximum Motorsports Subframe Connectors
-276.5rwhp / 284.6rwtq Dyno'ed 8.10.02 (before exhaust mods)
-312.6 rwhp / 307.8 rwtq Dyno'ed 8.09.03 (after exhaust mods)
-Autometer Phantom electric oil pressure & water temp gauges
-Fluidyne radiator
|
 |
Official Member
|
|
Posts: 699
Join Date: December 2003
Location: Fremont, CA
|
|
|
08-28-05, 11:58 PM
00-Saleen s281 #368 Supercharged Speedster 433rwhp/419rwtq KB @ 9psi & 91 pump gas
12" K&N & CAI, 90mmMAF, 75mmTB, BAP, 18x9 & 18x10 rims, 315/30/18 rears, 13" saleen drilled/sloted brakes
T56 6-speed, FRPP 3.55 Gears, Dual Kevlar 10-spline Clutch, Alum flywheel & Driveshaft, Steeda Tri-Ax shifter
1 3 5 R
|_|_|_| | | |
